I.S. specifies following total number of grades of tolerances__________________?

Related Mcqs:

Which of the following is not correct procedure to increase the fatigue limit_______________?

A. cold working B. shot peening C. surface decarburisation D. under-stressing E. all of the above...

In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?

A. decreasing the cross-section area of’ bar B. increasing the cross-section area of bar C. remain unaffected with cross-section area D. would depend upon other factors E. none of the above...

If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?

A. lOVZ B. 10VZtol5Vd C. 15Vdto20VZ D. 20Vdto30Vd E. 30V5″to40Vd...

Silver-based solder is used for__________________?

A. flaring B. brazing C. soft soldering D. fusion welding E. none of the above...

Basic hole is one_________________?

A. whose upper deviation is zero B. whose lower deviation is zero C. whose lower as well as upper deviations are zero D. does not exist E. none of the above...