In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?

Machine Design 24/02/2024

A. decreasing the cross-section area of’ bar
B. increasing the cross-section area of bar
C. remain unaffected with cross-section area
D. would depend upon other factors
E. none of the above

Related Mcqs:

    If a material fails below its yield point, failure would be due to___________________?
    A. straining B. fatigue C. creep D. sudden loading E. impact loading...
    The included angle in unified of American National threads is___________________?
    A. 60° B. 55° C. 47° D. 29° E. none of the above...
    If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
    A. lOVZ B. 10VZtol5Vd C. 15Vdto20VZ D. 20Vdto30Vd E. 30V5″to40Vd...
    The shear plane in case of bolts should_________________?
    A. be across threaded portion of shank B. be parallel to axis of bolt C. be normal to threaded portion of shank D. never be across the threaded portion E. none of the above...
    In hydrostatic bearings ____________________?
    A. the Oil film pressure is generated only by the rotation of the journal B. the oil film is maintained by supplying oil under pressure C. do not require external supply of lubricant D. grease is used for lubrication E. none of the above...

Leave a Reply

Your email address will not be published. Required fields are marked *