Search
.Management Sciences
Category: Machine Design
Yield point in fatigue loading as compared to static loading is__________________?
A. same
B. higher
C. lower
D. depends on other factors
E. none of the above
Stress concentration in static loading is more serious in__________________?
A. ductile materials
B. brittle materials
C. equally serious in both cases
D. depends on other factors
E. unpredictable
The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be_________________?
A. same in both cases
B. 2 times more
C. 3 times more
D. 4 times more
E. unpredictable
Brittle coating technique is used for_________________?
A. determining brittleness
B. protecting metal against corrosion
C. protecting metal against wear and tear
D. experimental stress analysis
E. non-destructive testing of metals
Split nut is a locking device in which_________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
B. a slot is cut partly in middle of nut and then slot reduced by tightening screw
C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the nut is screwed on the bolt causing a tight grip
D. through slots are made at top and a cotter-pin is passed through these and a hole in the bolt, and cotter pin splitted and bent in reverse direction at the other end
E. none of the above
If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
A. be independent of ratio of mass of load W to mass of bar (y)
B. increase with increase in y
C. decrease with decrease in y
D. depend on other considerations
E. none of the above
A key made from a cylindrical disc having segmental cross-section, is known as______________?
A. wood-ruff key
B. feather key
C. flat saddle key
D. gib head key
E. hollow saddle key
The endurance limit of a material with finished surface in comparison to rough surface is_________________?
A. more
B. less
C. same
D. more or less depending on quantum of load
E. unpredictable
The shock absorbing capacity of a bolt can be increased by___________________?
A. tightening it properly
B. increasing shank diameter
C. grinding the shank
D. using washer
E. making shank diameter equal to core diameter of thread
Castle nut is a locking device in which__________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
B. a slot is cut partly is middle of nut and then slot reduced by tightening a screw
C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the nut is screwed on the bolt causing a tight grip
D. through slots are made at top and a cotter pin is passed through these and a hole in the bolt, and cotter pin spitted and bent in reverse direction at other end
E. none of the above.
Recent Comments