Stress concentration in static loading is more serious in__________________?

Related Mcqs:

Which of the following is not correct procedure to increase the fatigue limit_______________?

A. cold working B. shot peening C. surface decarburisation D. under-stressing E. all of the above...

At low temperatures (say 75°C) the notched-bar impact value of steel____________________?

A. increases markedly B. decreases markedly C. remains same D. depends on heat treatment carried out E. none of the above...

Taper on the cotter and slot is provided_________________?

A. on both the sides B. on one side only C. on none of the sides D. may be provided anywhere E. none of the above...

If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?

A. diameter of bolt B. 0.75 x diameter of bolt C. 1.25 x diameter of bolt D. 1.5 x diameter of bolt E. 0.5 x diameter of bolt...

The designation M 33 x 2 of a bolt means___________________?

A. metric threads of 33 nos in 2 cm. B. metric threads with cross-section of 33 mm C. metric threads of 33 mm outside diameter and 2 mm pitch D. bolt of 33 mm nominal diameter having 2 threads per cm E. none of the above...