Which is correct statement ?

Machine Design 23/08/2020

A. a member made of steel will generally be more rigid than a member of equal load-carrying ability made of cast iron
B. a member made of cast iron will generally be. more rigid than a member of equal load carrying ability made of steel
C. both will be equally rigid
D. which one is rigid will depend on several other factors
E. none of the above

Related Mcqs:

    Which of the following is not correct procedure to increase the fatigue limit_______________?
    A. cold working B. shot peening C. surface decarburisation D. under-stressing E. all of the above...
    In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
    A. decreasing the cross-section area of’ bar B. increasing the cross-section area of bar C. remain unaffected with cross-section area D. would depend upon other factors E. none of the above...
    If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
    A. lOVZ B. 10VZtol5Vd C. 15Vdto20VZ D. 20Vdto30Vd E. 30V5″to40Vd...
    Silver-based solder is used for__________________?
    A. flaring B. brazing C. soft soldering D. fusion welding E. none of the above...
    For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately________________?
    A. 0.4 times B. 0.6 times C. 0.7 times D. 0.8 times E. 0.9 times the normal diameter of bolt...

Leave a Reply

Your email address will not be published. Required fields are marked *