Due to non sinusoidal waveform of the input current, the power factor of the rectifier is____________?

Power Electronics 23/08/2020

A. Negatively affected by firing angle
B. Negatively affected by distortion of the input current
C. Positively affected by both firing angle and distortion of the input current
D. Both (a) and (b)

Related Mcqs:

    If holding current of a thyristor is 2 mA then latching current should be_____?
    A. 0.01 A. B. 0.002 A. C. 0.009 A. D. 0.004 A....
    What is used to protect the SCR from over current ________________?
    A. CB and fuse. B. Heat sink. C. Snubber circuit. D. Voltage clamping device....
    The reverse recovery time of diode is trr = 3 μs and the rate off all of the diode current is di/dt = 30 A/μs. The storage charge current QRR is___________?
    A. 130 μs B. 135 μs C. 140 μs D. 145 μs...
    In radiative coupling, the emitter radiation field_____________?
    A. Decays as 1 / R, where R is the separation distance between the emitter and the receptor B. Decays as R, where R is the separation distance between the emitter and the receptor C. Decays as 1 / 2 R, where R is the separation distance between the emitter and the receptor D. Decays … In radiative coupling, the emitter radiation field_____________?Read More...
    Ripple factor is the ratio of______________________?
    A. Rms value of the ac component of load voltage to the dc voltage B. Average value of the ac component of load voltage to the peak value of voltage C. Average value of the dc component of load voltage to the ac voltage D. Peak value of the dc component of load voltage to … Ripple factor is the ratio of______________________?Read More...

Leave a Reply

Your email address will not be published. Required fields are marked *