Taper on the cotter and slot is provided_________________?

Related Mcqs:

If a material fails below its yield point, failure would be due to___________________?

A. straining B. fatigue C. creep D. sudden loading E. impact loading...

The permissible stress for carbon steel under static loading is generally taken as__________________?

A. 2000-3000 kg/pm2 B. 3000-4000 kg/cm2 C. 4000-4500 kg/cm2 D. 7500-10,000 kg/cm2 E. 10,000-15,000 kg/cm2...

Machine screws are________________?

A. similar to small size tap bolts except that a greater variety of shapes of heads are available B. slotted for a screw driver and generally used with a nut C. used to prevent relative motion be-tween two parts D. similar to stud E. none of the above...

The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for_________________?

A. reducing stress concentration B. ease of manufacture C. safety D. fullering and caulking E. all of the above...

In V-belt drive, belt touches______________?

A. at bottom B. at sides only C. both at bottom and sides D. could touch anywhere E. none of the above...