Machine screws are________________?

Machine Design 27/12/2020

A. similar to small size tap bolts except that a greater variety of shapes of heads are available
B. slotted for a screw driver and generally used with a nut
C. used to prevent relative motion be-tween two parts
D. similar to stud
E. none of the above

Related Mcqs:

    Stress concentration in cyclic loading is____________________?
    Which is correct statement ? A. very serious in brittle materials and less serious in ductile materials B. very serious in ductile materials and less serious in brittle materials C. equally serious in both types of materials D. seriousness would depend on other factors E. none of the above...
    Resistance to fatigue of a material is measured by________________?
    A. Young’s modulus B. coefficient of elasticity C. elastic limit D. ultimate tensile strength E. endurance limit...
    The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of____________?
    A. 0.25 B. 0.45 C. 0.55 D. 0.65 E. 0.75...
    In standard taper roller bearings, the angle of taper of outer raceway is___________________?
    A. 5° B. 8° C. 15° D. 25° E. 40°....
    The designation M 33 x 2 of a bolt means___________________?
    A. metric threads of 33 nos in 2 cm. B. metric threads with cross-section of 33 mm C. metric threads of 33 mm outside diameter and 2 mm pitch D. bolt of 33 mm nominal diameter having 2 threads per cm E. none of the above...

Leave a Reply

Your email address will not be published. Required fields are marked *