Why resistor is used in Snubber circuit_________________ ?

Power Electronics 21/05/2021

A. To minimize the loss
B. To minimize the charging current
C. To minimize the discharging current
D. All of these

Related Mcqs:

    A single phase one pulse controlled circuit has a resistance R and counter emf E load 400 sin(314 t) as the source voltage. For a load counter emf of 200 V, the range of firing angle control is _____?
    A. 30° to 150°. B. 30° to 180°. C. 60° to 120°. D. 60° to 180°....
    Rise time is defined by the interval when____________?
    A. gate current rises from 90 % to 100 % of it final value B. anode voltage drops from 90 % to 10 % of its initial value C. anode current rises 10 % to 90 % of its final value D. both B and C...
    In a single phase full wave rectifier, during blocking state the pea inverse voltage of diode is______________?
    A. V m B. 2 V m C. V m / 2 D. 4 V m...
    The maximum firing angle in the half wave controlled regulator is_____________?
    A. 180 degree B. 190 degree C. 200 degree D. 210 degree...
    Regulator sampling PWM is usually used in___________?
    A. High power inverters B. Rectifiers C. Low power inverters D. Only A. and B....

Leave a Reply

Your email address will not be published. Required fields are marked *