Rise time is defined by the interval when____________?

Power Electronics 01/11/2020

A. gate current rises from 90 % to 100 % of it final value
B. anode voltage drops from 90 % to 10 % of its initial value
C. anode current rises 10 % to 90 % of its final value
D. both B and C

Related Mcqs:

    Let of a thyristor Vc1, Vc2, Vc3 are forward break over voltage for gate current Ig1, Ig2, Ig3 respectively. Then________________?
    A. Vc1 > Vc2 > Vc3 when Ig1 > Ig2 > Ig3. B. Vc1 > Vc2 > Vc3 when Ig1 < Ig2 < Ig3. C. Vc1 = Vc2 = Vc3 any value of Ig. D. Vc1 > Vc2 > Vc3 when Ig1 ≥ Ig2 &Atil...
    An ideal switch is___________?
    A. Lossless B. Carry current in any direction when it is on C. Does not carry any current in any direction when it is off D. All of these...
    Advantages of HVDC transmission over AC system is / are____________?
    a. Reversal of power can be controlled by firing angle b. Very good dynamic behavior c. They can link two AC system operating unsynchronized d. All of these...
    If all the SCR’s of 3 phase PAC is replaced by diodes, they would be triggered_____________?
    A. 120 degree after the zero crossing of the corresponding line voltages B. 60 degree after the zero crossing of the corresponding line voltages C. 120 degree before the zero crossing of the corresponding line voltages D. 60 degree before the zero crossing of the corresponding line voltages...
    During the commutation period in 3 phase converter, overlap time is____________?
    A. Dependent on the load current B. Dependent on the voltage C. Dependent on both the load current and load voltage behind the short circuit current D. Independent on both the load current and load voltage...

Leave a Reply

Your email address will not be published. Required fields are marked *