High pressure fluid in a shell and tube heat exchanger should preferably be routed through the________________?

Process Equipment and Plant Design 28/04/2024

A. Tubes to avoid the expansion of high pressure shell construction
B. Shell side for smaller total pressure drop
C. Shell side, if the flow is counter-current and tube side if the flow is co-current
D. Shell side for large overall heat transfer co-efficient

Related Mcqs:

    Friction factor for turbulent flow in a new pipe is given by____________________?
    A. f = 16/NRe B. f = 0.04/(NRe)0.16 C. f = 0.22 NRe 0.5 D. f = 25/NRe...
    For high pressure process equipments/vessels, the connected nozzle should be____________________?
    A. Welded B. Screwed C. Flanged D. Brazed...
    With increase in the reflux ratio for a fixed production from a continuous binary distillation column, the ______________________ decreases?
    A. Fixed charges initially B. Running cost of cooling water for condenser C. Vapour & liquid load both D. Running cost of steam for reboiler...
    Pressure drop per tray in the atmospheric distillation column is about ________________ psi?
    A. 0.01 – 0.5 B. 0.07 – 0.12 C. 0.5 – 1.0 D. 1 – 3...
    Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele’s method, this method_________________?
    A. is more accurate in finding the number of equilibrium stages B. accounts for the enthalpy changes in the process C. Facilitates direct calculation of heat load on reboiler & condenser from, the diagram used in this method D. All A, B. & C....

Leave a Reply

Your email address will not be published. Required fields are marked *