Applications in which stresses are encountered in one direction only uses following type of threads____________________?

Related Mcqs:

In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?

A. decreasing the cross-section area of’ bar B. increasing the cross-section area of bar C. remain unaffected with cross-section area D. would depend upon other factors E. none of the above...

Which is correct statement ?

A. a member made of steel will generally be more rigid than a member of equal load-carrying ability made of cast iron B. a member made of cast iron will generally be. more rigid than a member of equal load carrying ability made of steel C. both will be equally rigid D. which one is … Which is correct statement ?Read More...

Taper on the cotter and slot is provided_________________?

A. on both the sides B. on one side only C. on none of the sides D. may be provided anywhere E. none of the above...

Oil in journal bearing should be applied at the point where load is________________?

A. nil or lightest B. maximum C. average D. any one of the above E. unpredictable...

Form coefficient of spring is _____________________?

A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. concerned With strength of wire of spring E. nothing...