The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?

Related Mcqs:

If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?

A. be independent of ratio of mass of load W to mass of bar (y) B. increase with increase in y C. decrease with decrease in y D. depend on other considerations E. none of the above...

In nitrated parts, the origins of the fatigue cracks will occur at__________________?

A. surface B. just below the surface C. within the core D. could occur anywhere E. none of the above...

If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?

A. lOVZ B. 10VZtol5Vd C. 15Vdto20VZ D. 20Vdto30Vd E. 30V5″to40Vd...

In standard taper roller bearings, the angle of taper of outer raceway is___________________?

A. 5° B. 8° C. 15° D. 25° E. 40°....

A bench vice has following type of threads____________________?

A. metric B. square C. buttress D. acme E. BSW...