The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?

Related Mcqs:

If an unsupported uniform cross sectional elastic bar is subjected to a longitudinal impact from a rigid bob moving with velocity v, then a compressive wave of intensity sc is propagated through the bar as follows______________________?

A. vpE B. vVvF C. WpE/2 D. IvHpE E. none of the above, where E = modulus of elasticity and p = mass density...

If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?

A. be independent of ratio of mass of load W to mass of bar (y) B. increase with increase in y C. decrease with decrease in y D. depend on other considerations E. none of the above...

The following type of nut is used with alien bolt____________________?

A. alien nut B. hexagonal nut C. slotted nut D. castle nut E. any one of the above...

The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?

A. 0.01 micron B. 0.1 micron C. 1 micron D. 10 microns E. 25 microns...

Castle nut is a locking device in which__________________?

A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly is middle of nut and then slot reduced by tightening a screw C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as … Castle nut is a locking device in which__________________?Read More...