In reaction turbine, draft tube is used_____________________?

Hydraulic Machines 22/03/2021

A. to transport water downstream without eddies
B. to convert the kinetic energy to flow energy by a gradual expansion of the flow cross-section
C. for safety of turbine
D. to increase flow rate
E. none of the above

Related Mcqs:

    For starting an axial flow pump, its delivery valve should be____________________?
    A. closed B. open C. depends on starting condition and flow desired D. could be either open or closed E. partly open and partly closed...
    Reaction turbines are used for____________________?
    A. low head B. high head C. high head and low discharge D. high head and high discharge E. low head and high discharge...
    The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°.___________________?
    The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°....
    Specific speed for reaction turbines ranges from___________________?
    A. 0 to 4.5 B. 10 to 100 C. 80 to 200 D. 250 to 300 E. none of the above...
    Francis, Kaplan and propeller turbines fall under the category of___________________?
    A. Impulse turbines B. Reaction turbines C. Axial flow turbines D. Mixed flow turbines E. Reaction-cum-impulse turbines...

Leave a Reply

Your email address will not be published. Required fields are marked *