In the axial flow gas turbine, the work ratio is the ratio of____________________?

Compressors, Gas Turbines and Jet Engines 29/05/2020

A. compressor work and turbine work
B. output and input
C. actual total head tempeature drop to the isentrpic total head drop from total head inlet to static head outlet
D. actual compressor work and theoretical comprssor work
E. none of the above

Related Mcqs:

    Maximum work is done in compressing air when the compression is_________________?
    A. isothermal B. adiabatic C. polytropic D. any one of the above E. none of the above...
    The compressor performance at higher altitude compared to sea level will be _______________?
    A. same B. higher C. lower D. dependent on other factors E. none of the above...
    Diffuser in a compressor is used to _____________________?
    A. increase velocity B. make the flow stream-line C. convert pressure energy into kinetic energy D. convert kinetic energy into pressure energy E. increase degree of reaction...
    Actual compression curve is___________________?
    A. same as isothermal B. same as adiabatic C. better than isothermal and adiabatic D. in between isothermal and adiabatic E. none of the above...
    Propulsive efficiency is defined as ratio of___________________?
    A. thrust power and fuel energy B. engine output and propulsive power C. propulsive power and fuel input D. thrust power and propulsive power E. none of the above...

Leave a Reply

Your email address will not be published. Required fields are marked *