Search
.Management Sciences
Category: Refrigeration and Air Conditioning
Choose the wrong statement ?
A. Temperature of medium being cooled must be below that of the evaporator
B. Refrigerant leaves the condenser as liquid
C. All solar thermally operated absorption systems are capable only of intermittent operation
D. frost on evaporator reduces heat transfer
E. refrigerant is circulated in a refrigeration system to transfer heat
The COP of a vapor compression plant in comparison to vapor absorption plant is ________________?
A. more
B. less
C. same
D. more/less depending on size of plant
E. unpredictable
Super heating in a refrigeration cycle __________________?
A. increases COP
B. decreases COP
C. COP remains unaltered
D. other factors decide COP
E. unpredictable
A refrigerant should have _____________________?
Pick up the wrong statement ?
A. Tow specific heat of liquid
B. high boiling point
C. high latent heat of vaporisation
D. higher critical temperature
E. low specific volume of vapour
In S.J. unit, one ton of refrigeration is equal to___________________?
A. 210 kJ/min
B. 21 kJ/min
C. 420 kJ/min
D. 840 kJ/min
E. 105 kJ/min
Vertical lines on pressure-enthalpy chart show constant_______________?
A. pressure lines
B. temperature lines
C. total heat lines
D. entropy lines
E. volume lines
The advantage of dry compression is that________________?
A. it permits higher speeds to be used
B. it permits complete evaporation in the evaporator
C. it results in high volumetirc and mechanical efficiency
D. all of the above
E. none of the above
A standard ice point temperature corresponds to the temperature of ___________________?
A. water at 0°C
B. ice at – 4°C
C. solid and dry ice
D. mixture of ice, water and vapour under equilibrium conditions under NTP conditions
E. mixture of ice and water Under equilibrium conditions
In vapor compression cycle, the condition of refrigerant is very wet vapor________________?
A. after passing through the condenser
B. before passing through the condenser
C. after passing through the expansion or throttle valve
D. before entering the expansion valve
E. before entering the compressor
Mass flow ratio of NH3 in comparison to Freon-12 for same refrigeration load and same temperature limits is of the order of___________________?
A. 1 : 1
B. 1 : 9
C. 9 : 1
D. 1 : 3
E. 3 : 1
Recent Comments