Search
.Management Sciences
Category: Electrical Engineering Mcqs
The type of D.C. motor used for shears and punches is_____________?
A. shunt motor
B. series motor
C. differential compoutid D.C. motor
D. cumulative compound D.C. motor
Those magnetic materials are best suited for making armature and transformer cores which have ________ permeability and ________ hystersis loss
A. high, high
B. low, high
C. high, low
D. low, low
The efficiency of the copper oxide rectifier seldom exceeds____________?
A. 90 to 95%
B. 85 to 90%
C. 80 to 85%
D. 65 to 75%
If all the SCR’s of 3 phase PAC is replaced by diodes, they would be triggered_____________?
A. 120 degree after the zero crossing of the corresponding line voltages
B. 60 degree after the zero crossing of the corresponding line voltages
C. 120 degree before the zero crossing of the corresponding line voltages
D. 60 degree before the zero crossing of the corresponding line voltages
In Ward-Leonard control the lower limit of speed is imposed by________?
A. residual magnetism of the generator
B. core losses of motor
C. mechanical losses of motor and generator together
D. all of the above
Regenerative cycle thermal efficiency_______________?
A. is always greater than simple Rankine thermal efficiency
B. is greater than simple Rankine cycle thermal efficiency only when steam is bled at particular pressure
C. is same as simple Rankine cycle thermal efficiency
D. is always less than simple Rankine cycle thermal efficiency
Which of the following materials is used in the manufacture of resistance grids to be used in the starters of large motors ?
A. Copper
B. Aluminium
C. Steel
D. Cast-iron
If a D.C. series motor is operated on A.C. supply, it will____________?
A. spark excessively
B. have poor efficiency
C. have poor power factor
D. all of the above
A transistor takes_____________ inductor on a silicon IC chip?
A. Less space than
B. More space than
C. Same space as
D. None of the above
The first goal to accomplish in analyzing a complex series-parallel circuit is to____________?
A. solve for all the voltage drops
B. solve for the total current and resistance
C. equate all series components
D. equate all parallel components
Recent Comments