Regenerative cycle thermal efficiency_______________?

Power Generation 02/04/2024

A. is always greater than simple Rankine thermal efficiency
B. is greater than simple Rankine cycle thermal efficiency only when steam is bled at particular pressure
C. is same as simple Rankine cycle thermal efficiency
D. is always less than simple Rankine cycle thermal efficiency

Related Mcqs:

    The draught produced by chimney of given height at given outside temperature___________?
    A. decreases if the chimney gas temperature increases B. increases if the chimney gas temperature increases C. remains same irrespective of chimney gas temperature D. may increase or decrease...
    In jet type condensers___________?
    A. cooling water passes through tubes and steam surrounds them B. steam passes through tubes and cooling water surrounds them C. steam and cooling water mix D. steam and cooling water do not mix...
    The efficiency of a modern boiler using coal and heat recovery equipment is about_____________?
    A. 25 to 30% B. 40 to 50% C. 65 to 70% D. 85 to 90%...
    The value of the reheat factor is of the order of_____________?
    A. 0.8 to 1.0 B. 1.0 to 1.05 C. 1.1 to 1.5 D. above 1.5...
    If the load factor of a power station is high then its cost of generation will be_______?
    A. High. B. Low. C. Remain same. D. Depend upon plant type....

Leave a Reply

Your email address will not be published. Required fields are marked *