Search
.Management Sciences
Category: Fluid Mechanics
Flow at constant rate through a tapering pipe is________________?
1. steady flow
2. uniform flow
3. unsteady flow
4. non-uniform flow
The correct answer is?
A. (1) and (2)
B. (1)and(iv)
C. (2) and (3)
D. (2) and (4)
Select the correct statement?
A. The absolute roughness of a pipe de-creases with time
B. A pipe becomes smooth after using for long time
C. The friction factor decreases with time
D. The absolute roughness increases with time
An open tank contains 1 m deep water with 50 cm depth of oil of specific gravity 0.8 above it. The intensity of pressure at the bottom of tank will be________________?
A. 4 kN/m2
B. 10 kN/m2
C. 12 kN/m2
D. 14 kN/m2
In case of an airfoil, the separation of flow occurs________________?
A. at the extreme rear of body
B. at the extreme front of body
C. midway between rear and front of body
D. any where between rear and front of body depending upon Reynolds number
Coefficient of velocity for Borda’s mouth piece running full is________________?
A. 0.611
B. 0.707
C. 0.855
D. 1.00
The theoretical value of coefficient of contraction of a sharp edged orifice is_______________?
A. 0.611
B. 0.85
C. 0.98
D. 1.00
In series-pipe problems_______________?
A. the head loss is same through each pipe
B. the discharge is same through each pipe
C. a trial solution is not necessary
D. the discharge through each pipe is added to obtain total discharge
The discharge over a broad crested weir is maximum when the depth of flow is_______________?
A. H/3
B. H/2
C. 2 H/5
D. 2 H/3
where H is the available head
The discharge through a V- notch varies as______________?
A. H1/2
B. H3’2
C. H5/2
D. H5’4 where H is head
Recent Comments