Search
.Management Sciences
Category: Process Equipment and Plant Design
For a given design of bubble cap, the number of bubble caps to be used per tray is set by the _________________?
A. Allowable gas velocity through the slots
B. Plate spacing
C. Diameter of the column
D. All A., B. and C.
Multiple blade paddle agitator is used for mixing high viscosity liquids/paste in which the paddle diameter is commonly 0.8 times the tank diameter. However, the width of the blade is in the range of ______________ times the paddle diameter?
A. 0.1 to 0.25
B. 0.3 to 0.5
C. 0.5 to 0.6
D. 0.65 to 0.80
Pick out the wrong statement pertaining to shell and tube heat exchanger_______________?
A. Clearance between shell & baffles and between tube & baffles should be minimum to avoid
by-passing of the fluid, but it should be enough to permit the removal of tube bundle
B. Baffles are supported independently of the tubes by tie rods and positioned by spacers
C. Tie rods are fixed at one end in the tube sheet by making blind holes and the minimum
number of tie rods is 4 with at least 10 mm diameter
D. Bracket supports are used for horizontal shell, while saddle support is used for vertical shell
A ‘rupture disc’ is provided in chemical equipments as an accessory meant for ___________________?
A. Relieving excess pressure
B. Creating turbulence
C. Enhancing mixing rate
D. Avoiding vortex formation
For given number of passes, pitch & tube diameter, the maximum number of tubes that can be accommodated in a shell of tripled inside diameter will be ____________ times?
A. About 9
B. Considerably more than 9
C. Considerably less than 9
D. About 3
Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about ______________ percent of the total thickness?
A. 1 to 5
B. 10 to 20
C. 30 to 40
D. 40 to 50
Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (saturated liquid curve), dew point curve (saturated vapour curve) and equilibrium tie lines. As compared to McCabe-Thiele’s method, this method_________________?
A. is more accurate in finding the number of equilibrium stages
B. accounts for the enthalpy changes in the process
C. Facilitates direct calculation of heat load on reboiler & condenser from, the diagram used in
this method
D. All A, B. & C.
Heat transfer co-efficient, hG(Kcal/hr.m2 .°C) and mass velocity of air, G (kg/hr.m2 ) for air flow parallel to the surface in case of constant drying rate in batch drying is related as hG = 0.0176G0.8. But when the flow of air perpendicular to the surface is encountered, this equation changes to ____________________?
A. hG = 1.004G0.37
B. 1.004G0.8
C. hG = 0.0176G0.37
D. 0.0176G1.37
The equivalent diameter for pressure drop is _______________ that for heat transfer?
A. Smaller than
B. Greater than
C. Equal to
D. Not related with
Recent Comments