The maximum di/dt in a SCR is____________?

Power Electronics 30/10/2020

A. Directly proportional to supply voltage
B. Directly proportional to inductance in the circuit
C. Inversely proportional to supply voltage
D. Both A and B

Related Mcqs:

    Thyristor can be protected from over voltages by using____________?
    A. voltage clamping device. B. fuse. C. heat sink. D. snubber circuit....
    Let of a thyristor Vc1, Vc2, Vc3 are forward break over voltage for gate current Ig1, Ig2, Ig3 respectively. Then________________?
    A. Vc1 > Vc2 > Vc3 when Ig1 > Ig2 > Ig3. B. Vc1 > Vc2 > Vc3 when Ig1 < Ig2 < Ig3. C. Vc1 = Vc2 = Vc3 any value of Ig. D. Vc1 > Vc2 > Vc3 when Ig1 ≥ Ig2 &Atil...
    ON state voltage drop across SCR lie between the range_____________?
    A. 0 – 0.5 V. B. 0.5 – 1 V. C. 1 – 1.5 V. D. 1.5 – 2 V....
    In a 3 phase CSI, if the required line output voltages are balanced and 120 degree out of phase, then the chopping angles are used to eliminate only the harmonics at frequencies
    A. 5 B. 7 C. 11 D. All of these...
    The Graetz bridge makes excellent use of ______________?
    A. Current transformer B. Potential transformer C. Power transformer D. SCR...

Leave a Reply

Your email address will not be published. Required fields are marked *