BCT is used for____________?

Power Electronics 16/07/2021

A. High power phase control
B. High power current control
C. Low power current control
D. Low power phase control

Related Mcqs:

    Under over voltage condition impedance offered by the voltage clamping device is__________?
    A. low B. High C. moderate D. infinity...
    During which time maximum conduction spreading take place in the thyristor during turn ON?
    A. Delay time B. Spread time C. Rise time D. Same for every case...
    In a load commutated DC – DC chopper, the capacitor has a_____________?
    A. Symmetric triangular voltage across itself B. Symmetric rectangular voltage across itself C. Symmetric trapezoidal voltage across itself D. Symmetric sinusoidal voltage across itself...
    The maximum firing angle in the half wave controlled regulator is_____________?
    A. 180 degree B. 190 degree C. 200 degree D. 210 degree...
    In square wave operation mode of 3 phase VSI, the VSI
    A. Can control the load voltage B. Cannot control the load voltage C. Cannot control the load voltage except by means of dc link voltage D. Cannot control the load voltage except by means of dc link current...

Leave a Reply

Your email address will not be published. Required fields are marked *