When a transistor is connected in common emitter mode, it with have__________?

Analog Electronics 11/04/2024

A. negligible input resistance and high output resistance
B. high input resistance and low output resistance
C. medium input resistance and high output resistance
D. low input resistance as well as output resistance

Related Mcqs:

    Thermal runaway is not possible in FET because as the temperature of FET increases_________________?
    A. the mobility decreases B. the transconductance increases C. the drain current increases D. none of the above...
    A source follower using an FET usually has a voltage gain which is___________?
    A. greater than +100 B. slightly less than unity but positive C. exactly unity but negative D. about -10...
    Introducing a resistor in the emitter of a common amplifier stabilizes the dc operating point against variations in____________?
    A. Only the temperature B. only the β of the transistor C. Both Temperature & β D. None of the above...
    In a CB amplifier the maximum efficiency could be____________?
    A. 99% B. 85% C. 50% D. 25%...
    An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?
    A. 795mV B. 395mV C. 795 mV D. 39.5mV...

Leave a Reply

Your email address will not be published. Required fields are marked *