Creep is the_______________?

Railway Engineering 16/04/2021

A. longitudinal movement of rail
B. lateral movement of rail
C. vertical movement of rail
D. difference in level of two rails

Related Mcqs:

    The purpose of providing fillet in a rail section is to_________________?
    A. increase the lateral strength B. increase the vertical stiffness C. avoid the stress concentration D. reduce the wear...
    Minimum depth of ballast cushion for a Broad Gauge wooden sleeper of size 275x25x13 cm with 75cm sleeper spacing is________________?
    A. 15 cm B. 20 cm C. 25 cm D. 30cm...
    The compensation for curvature on gradient for Meter Gauge is given by________________?
    A. 70/R B. 52.5/R C. 35/R D. 105/R where R is radius of curve...
    Which of the following mechanical devices is used to ensure that route cannot be changed while the train is on the point even after putting back the signal ?
    A. detectors B. point lock C. iock bar D. stretcher bar...
    The desirable rate of change of cant deficiency in case of Metre Gauge is_______________?
    A. 20 mm/sec B. 35 mm/sec C. 55 mm/sec D. 65 mm/sec...

Leave a Reply

Your email address will not be published. Required fields are marked *