Search
.Management Sciences
A. sides towards the centre
B. centre towards the sides
C. lower edge towards the upper edge
D. upper edge towards the lower edge
Related Mcqs:
- Reaction time of a driver_______________?
- A. increases with increase in speed B. decreases with increase in speed C. is same for all speeds D. none of the above...
- For design, that length of transition curve should be taken which is_____________?
- A. based on allowable rate of change of centrifugal acceleration B. based on rate of change of super elevation C. higher of (A) and (B) D. smaller of (A) and (B)...
- Centre line markings are used_____________?
- A. to designate traffic lanes B. in roadways meant for two way traffic C. to indicate that overtaking is not permitted D. to designate proper lateral placement of vehicles before turning to different directions...
- Percentage of free carbon in bitumen is______________?
- A. more than that in tar B. less than that in tar C. equal to that in tar D. none of the above...
- The maximum spacing of contraction joints in rigid pavements is_____________?
- A. 2.5 m B. 3.5 m C. 4.5 m D. 5.5m...
Recent Comments