For design, that length of transition curve should be taken which is_____________?

Highway Engineering 09/11/2020

A. based on allowable rate of change of centrifugal acceleration
B. based on rate of change of super elevation
C. higher of (A) and (B)
D. smaller of (A) and (B)

Related Mcqs:

    Stopping sight distance is always_______________?
    A. less than overtaking sight distance B. equal to overtaking sight distance C. more than overtaking sight distance D. none of the above...
    The value of ruling gradient in plains as per IRC recommendation is______________?
    A. 1 in 12 B. 1 m 15 C. 1 in 20 D. 1 in 30...
    Centre line markings are used_____________?
    A. to designate traffic lanes B. in roadways meant for two way traffic C. to indicate that overtaking is not permitted D. to designate proper lateral placement of vehicles before turning to different directions...
    The number of repetitions, which the pavement thickness designed for a given wheel load should be able to support during the life of pavement is______________?
    A. 1000 B. 10000 C. 100000 D. 1000000...
    The aggregates required for one kilometer length of water bound macadam road per meter width and for 10 mm thickness is________________?
    A. 8 cubic meter B. 10 cubic meter C. 12 cubic meter D. 15 cubic meter...

Leave a Reply

Your email address will not be published. Required fields are marked *