Battening is preferable when the________________?

Design of Steel Structures 07/05/2021

i) column carries axial load only
ii) space between the two main components is not very large
iii) column is eccentrically loaded
The correct answer is

A. only (i)
B. only (iii)
C. (i) and (ii)
D. (ii) and (iii)

Related Mcqs:

    The difference between gross diameter and nominal diameter for the rivets up to 25 mm diameter is__________________?
    A. 1.0 mm B. 1.5 mm C. 2.0 mm D. 2.5 mm...
    The slenderness ratio of a column supported throughout its length by a masonry wall is________________?
    A. zero B. 10 C. 100 D. infinity...
    As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
    A. 121 B. 161 C. 201 D. 251 where t = thickness of thinnest flange plate...
    Pitch of tacking rivets, when double angles connected back to back and acting as tension members should not be more than_________________?
    A. 500 mm B. 600 mm C. 1000 mm D. 300 mm...
    If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
    A. 0 B. 0.5 C. between 0.5 and 1.0 D. 1.0...

Leave a Reply

Your email address will not be published. Required fields are marked *