Search
.Management Sciences
A. lesser of 200 mm and 12 t
B. lesser of 200 mm and 161
C. lesser of 300 mm and 32 t
D. lesser of 3 00 mm and 24 t
where t is thickness of thinnest outside plate or angle
Related Mcqs:
- Bending compressive and tensile stresses respectively are calculated based on_________________?
- A. net area and gross area B. gross area and net area C. net area in both cases D. gross area in both cases...
- A circular column section is generally not used in actual practice because________________?
- A. it is uneconomical B. it cannot carry the load safely C. it is difficult to connect beams to the round sections D. all of the above...
- As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
- A. 121 B. 161 C. 201 D. 251 where t = thickness of thinnest flange plate...
- The bracing provided in the plane of end posts is called__________________?
- A. sway bracing B. portal bracing C. top lateral bracing D. bottom lateral bracing...
- The capacity of the smallest pressed steel tank is__________________?
- A. 1000 litre B. 1650 litre C. 1950 litre D. 2450 litre...
Recent Comments