As compared to ordinary portland cement, high alumina cement has______________?

Design of Concrete Structures 29/12/2020

A. higher initial setting time but lower final setting time
B. lower initial setting time but higher final setting time
C. higher initial and final setting times
D. lower initial and final setting times

Related Mcqs:

    The approximate value of the ratio between direct tensile strength and flexural strength is_____________?
    A. 0.33 B. 0.5 C. 0.75 D. 1.0...
    For a simply supported beam of span 15m, the minimum effective depth to satisfy the vertical deflection limits should be________________?
    A. 600 mm B. 750 mm C. 900 mm D. more than 1 m...
    The permissible diagonal tensile stress in reinforced brick work is_____________?
    A. about 0.1 N/mm2 B. zero C. 0.3 N/mm2 to 0.7 N/mm2 D. about 1.0 N/mm2...
    In counterfort retaining walls, the main reinforcement in the stem at support is_______________?
    A. not provided B. provided only on inner face C. provided only on front face D. provided both on inner and front faces...
    Stress strain curve of high tensile steel_______________?
    A. has a definite yield point B. does not show definite yield point but yield point is defined by 0.1% proof stress C. does not show definite yield point but yield point is defined by 0.2% proof stress D. does not show definite yield point but yield point is defined by 2% proof stress...

Leave a Reply

Your email address will not be published. Required fields are marked *