Wind load consideration in the design of a support can be neglected, when the vessel is___________________?

Process Equipment and Plant Design 22/12/2020

A. Tall (say 30 metres), but is full of liquid
B. Tall but empty
C. Short (< 2 m) and housed indoor
D. None of these

Related Mcqs:

    Power required for agitation depends upon the______________________?
    A. Height & properties of the liquid B. Agitator type & speed of agitation C. Size of agitator & the tank D. All A., B. and C....
    _____________ shaped roof is the most commonly used roof for cylindrical storage tanks?
    A. Conical B. Flat C. Dome D. Umbrella...
    The absorption factor is defined as (where, S1 = slope of the equilibrium curve, S2 = slope of the operating line) ?
    A. S1/S2 B. S1.S2 C. S2/S1 D. 1/S1.S2...
    A pipe is generally made of circular cross-section, because a circular cross-section has the____________________?
    A. Higher structural strength B. Lowest surface area requirement for a given volume C. Both A. & B. D. None of these...
    Holes of a sieve tray are arranged in triangular pitch of _________________ times the hole diameter?
    A. 1.5 to 2 B. 2.5 to 5 C. 5 to 10 D. 10 to 15...

Leave a Reply

Your email address will not be published. Required fields are marked *