Pick out the wrong statement?

Process Equipment and Plant Design 15/03/2021

A. The tensile strength of a brittle material is less than its compressive strength
B. The compressive strength of a ductile material is less than its tensile strength
C. In a thick cylindrical shell, the hoop stress is maximum at the inner radius
D. The value of crushing load is more than that of buckling load for long columns

Related Mcqs:

    Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than ______________ of the head?
    A. 6% of I.D. B. 3 times the thickness C. Either A. or B., whichever is larger D. Either A. or B., whichever is smaller...
    Low pressure steam (with saturation temperature between 105 to 120°C) is usually used in the vacuum evaporators, which normally employ a vacuum of about _______________ mm Hg (referred to a 760 mm mercury barometer)?
    A. 250 B. 450 C. 650 D. 750...
    Which of the following packing materials provides for maximum mass transfer ?
    A. Raschig rings B. Raschig rings C. Cross-partition rings D. All give the same value...
    The practical representative values of HETP for a number of commercial operations lies within a range of ______________ metre?
    A. 0.1-0.2 B. 0.2-0.5 C. 0.4-0.9 D. 1.2-1.5...
    In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon______________________?
    A. Baffle spacing B. Clearance C. Pitch D. None of these...

Leave a Reply

Your email address will not be published. Required fields are marked *