(Le/D) for a Tee (used as elbow, entering branch) would be ____________________?

Process Equipment and Plant Design 14/03/2021

A. Less than that for Tee (used as elbow, entering run)
B. More than that for Tee (used as elbow, entering run)
C. Around 90
D. Both B. and C.

Related Mcqs:

    What is the slope of the feed line, if the feed to a distillation column is a saturated liquid ?
    A. 0 B. ∞ C. > 1 D. < 1...
    The dust collection efficiency of a cyclone separator_________________?
    A. Decreases with increase in gas flow rate B. Is inversely proportional to the mass of the dust particle C. Is directly proportional to the radius of the dust particle path D. None of these...
    The thickness of heat transfer plates used in the plate type heat exchanger ranges from _____________ mm, pressed in a single piece provided with grooves & corrugations?
    A. 0.3 to 0.8 B. 1.25 to 3.125 C. 3.5 to 7.0 D. 8 to12...
    Nominal size of a pipe is an indication of its _______________ diameter?
    A. Inner B. Outer C. Approximate D. None of these...
    Shell side heat transfer co-efficient in case of square pitch as compared to the triangular pitch under similar condition of fluid flow and tube size is_____________?
    A. More B. Same C. Less D. Twice...

Leave a Reply

Your email address will not be published. Required fields are marked *