Which of the following gives the work required for size reduction of coal to -200 mesh in a ball mill most accurately?

Related Mcqs:

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter) ?

A. 0.5 D B. D C. 1.5 D D. 2 D...

In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?

A. Primary B. Secondary C. Fine D. Ultrafine...

Filtration capacity of a rotary drum vacuum filter depends upon the_______________?

A. Cake thickness B. Characteristics of the feed slurry C. Both A. & B. D. Neither A. nor B....

Fluid energy mill comes in the category of________________?

A. Grinder B. Crusher C. Cutter D. Ultrafine grinder...

During agitation of liquids, power consumption during laminar flow is not proportional to the ________________?

A. Density of the liquid B. Viscosity of the liquid C. Cube of impeller diameters D. Square of rotational speed...