Ostwald charts are meant for__________________?

Furnace Technology 20/02/2021

A. Computing the excess/deficiency of combustion air
B. Calculation of flue gas temperature
C. Computation of flue gas analysis
D. None of these

Related Mcqs:

    The heating capacity of muffle furnace depends on the_________________?
    A. Surface area & emissivity of the stock B. Properties of the muffle wall (temperature, area, and emissivity) C. Both A. & B. D. Neither A. nor B....
    Soaking pits are meant for heating steel_________________?
    A. Ingots B. Coils C. Sheets D. Slabs...
    In low or standard frequency induction furnace, heat is produced by the_______________________?
    A. Combination of induced current and skin effect B. Induction and resistance C. Current flow through a heating element D. None of these...
    Higher furnace temperature cannot be achieved by use of a lean fuel gas in the furnace by_________________?
    A. Increasing the draft in the furnace B. Preheating the fuel gas C. Oxygen enrichment of combustion air D. Preheating the combustion air...
    Size of the combustion chamber of a furnace depends upon the ___________________?
    A. Heat release rate of the fuel B. Preheat temperature of fuel & air C. Method of mixing the fuel & air D. All A., B. and C....

Leave a Reply

Your email address will not be published. Required fields are marked *