The maximum adiabatic flame temperature is attained, when the fuel is burnt with ______________________?

Fuels and Combustion 20/12/2020

A. Theoretically required amount of air
B. More than theoretically required amount of air
C. Less than theoretically required amount of air
D. Theoretically required amount of oxygen

Related Mcqs:

    Pitch creosote mixture (PCM) as compared to furnace oil is a better fuel, because its ___________________?
    A. Emissivity factor is higher B. Sulphur content is lower C. Flue gas has lower dew point thereby facilitating more waste heat recovery D. All A., B. and C....
    __________ is used as jet engine fuel ?
    A. Petrol B. Diesel C. Kerosene D. LPG...
    The calorific value of a gas of composition CO2 = 20%, H2 = 50%, CH4 = 30%, is y. If the composition of gas is changed to H2 = 50%, CH4 = 30%, CO2 = 10%, N2 = 10%, then the calorific value will be___________________?
    A. y B. 0.95 y C. 1.05 y D. 1.8 y...
    Actual flame temperature is always lower than the adiabatic flame temperature, because there is________________?
    A. No possibility of obtaining complete combustion at high temperature B. Always loss of heat from the flame C. Both A. and B. D. Neither A. nor B....
    The optimum percentage of excess air for combustion depends upon the _______________ of the fuel?
    A. Type (solid, liquid or gaseous) B. Calorific value C. Sulphur content D. Ignition temperature...

Leave a Reply

Your email address will not be published. Required fields are marked *