In a gas-liquid shell and tube heat exchanger, the_________________?

Chemical Heat Transfer 03/10/2021

A. Presence of a non-condensable gas decreases the condensing film co-efficient
B. Gases under high pressure are routed through the tube side, because high pressure gases are
corrosive in nature
C. Gases to be heated/cooled is normally routed through the shell side, because the corrosion
caused by the cooling water or steam condensate remain localised to the tubes
D. All A, B. & C.

Related Mcqs:

    For a liquid in laminar flow through a very long tube, when the exit fluid temperature approaches the wall temperature, the equation to be used is______________?
    A. Nu = 0.023 Re0.8. Pr0.4 B. Nu = (π/2) Gz C. Nu = (2/π) Gz D. Nu = 2Gz0.5...
    Corrosiveness of steam condensate is due to the presence of________________?
    A. CO2 B. Dissolved O2 C. Both A. & B. D. Neither A. nor B....
    Maximum heat transfer rate is achieved in _____________ flow?
    A. Co-current B. Counter-current C. Turbulent D. Laminar...
    The range of electromagnetic spectrum important in heat transfer by radiation is ______________ microns?
    A. 0.38-0.78 B. 0.5-50 C. 100-1000 D. 5-50...
    Out of the following four assumptions used in the derivation of the equation for LMTD [LMTD = (Δt1 – Δt2)/ln(Δt1/Δt2)], which one is subject to the largest deviation in practice ?
    A. Constant overall heat transfer co-efficient. B. Constant rate of fluid flow C. Constant specific heat D. No partial phase change in the system...

Leave a Reply

Your email address will not be published. Required fields are marked *