A hydraulic accumulator normally consists of________________?

Hydraulic Machines 24/12/2021

A. two cylinders, two rams and a storage device
B. a cylinder and a ram
C. two co-axial rams and two cylinders
D. a cylinder, a piston, storage tank and control valve
E. special type of pump with storage device and a pressure regulator

Related Mcqs:

    One horsepower is equal to_________________?
    A. 102 watts B. 75 watts C. 550 watts D. 736 watts E. 33000 watts...
    For small discharge at high pressure, following pump is preferred_____________________?
    A. centrifugal B. axial flow C. mixed flow D. propeller E. reciprocating...
    The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°.___________________?
    The angle of taper on draft tube is A. greater than 15° B. greater than 8° C. greater than 5° D. less than 8° E. less than 3°....
    Pressure intensifier increases the pressure in proportion to____________________?
    A. ratio of diameters B. square of ratio of diameters C. inverse ratio of diameters D. square of inverse ratio of diameters E. fourth power of ratio of diameters...
    In reaction turbine, draft tube is used_____________________?
    A. to transport water downstream without eddies B. to convert the kinetic energy to flow energy by a gradual expansion of the flow cross-section C. for safety of turbine D. to increase flow rate E. none of the above...

Leave a Reply

Your email address will not be published. Required fields are marked *