Which of the following conditions is to be satisfied both in elastic and plastic analysis ?

Related Mcqs:

Bending compressive and tensile stresses respectively are calculated based on_________________?

A. net area and gross area B. gross area and net area C. net area in both cases D. gross area in both cases...

According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

A. lesser of 200 mm and 12 t B. lesser of 200 mm and 161 C. lesser of 300 mm and 32 t D. lesser of 3 00 mm and 24 t where t is thickness of thinnest outside plate or angle...

As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?

A. 121 B. 161 C. 201 D. 251 where t = thickness of thinnest flange plate...

In the virtual work method, the virtual quantity is_________________?

A. displacement B. load C. slope D. moment...

Bearing stiffeners are provided at________________?

i) the supports ii) the mid span iii) the point of application of concentrated loads The correct answer is? A. only (i) B. both (i) and (ii) C. both (i) and (iii) D. (i), (ii) and (iii)...