When a transistor is connected in common emitter mode, it with have__________?

Related Mcqs:

Thermal runaway is not possible in FET because as the temperature of FET increases_________________?

A. the mobility decreases B. the transconductance increases C. the drain current increases D. none of the above...

A source follower using an FET usually has a voltage gain which is___________?

A. greater than +100 B. slightly less than unity but positive C. exactly unity but negative D. about -10...

Introducing a resistor in the emitter of a common amplifier stabilizes the dc operating point against variations in____________?

A. Only the temperature B. only the β of the transistor C. Both Temperature & β D. None of the above...

In a CB amplifier the maximum efficiency could be____________?

A. 99% B. 85% C. 50% D. 25%...

An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?

A. 795mV B. 395mV C. 795 mV D. 39.5mV...