Search
.Management Sciences
Category: Compressors, Gas Turbines and Jet Engines
Turbofan engine employs ____________________ ?
A. one air stream
B. two or more air streams
C. no air stream
D. solid fuel firing
E. rocket principle for its operation
In air breathing jet engine, the jet is formed by expanding__________________?
A. gases
B. solids
C. liquid
D. plasma
E. highly heated atmospheric air
It is not possible to use closed gas turbine cycle in aeronautical engines because_________________ ?
A. it is inefficient
B. it is bulky
C. it requires cooling water for its operation
D. non of theses
Separators in compressor installations are located_____________________?
A. before intercooler
B. after intercooler
C. after receiver
D. between after-cooler and air receiver
E. before suction
Free air is the air at________________?
A. atmospheric conditions at any specific location
B. 20°C and 1 kg/cm2 and relative humidity of 36%
C. 0°C and standard atmospheric conditions
D. 15°C and 1 kg/cm2
E. 25°C, 1 kg/cm2 and relative humidity of 50%.
The pressure ratio of an ideal vaned compressor with increase in mass flow rate_________________?
A. increases
B. decreases
C. remains constant
D. first decreases and then increases
E. unpredictable
Euler’s equation is applicable for__________________?
A. centrifugal compressor
B. axial compressor
C. pumps
D. all of the above
E. none of the above
The volumetric efficiency of a compressor falls roughly as follows for every 100 m increase in elevation___________________?
A. 0.1%
B. 0.5%
C. 1.0%
D. 5%
E. 10%.
Efficiency of gas turbine is increased by________________ ?
A. reheating
B. inter cooling
C. adding a regenerator
D. all of the above
E. none of the above
The volumetirc efficiency of a compressor is calculated on the basis of __________________?
A. volume of air inhaled at working conditions
B. volume of air inhaled at N.T.P. conditions
C. volume at 0°C and 1 kg/cm2
D. volume at 20°C and 1 kg/cm2
E. none of the above
Recent Comments