Search
.Management Sciences
Category: Power Generation
For forced draught system, the function of chimney is mainly_____________?
A. to produce draught to accelerate the combustion of fuel
B. to discharge gases high up in the atmosphere to avoid hazard
C. to reduce the temperature of the hot gases discharged
D. none of the above
The pressure on the two sides of the impulse wheel of a steam turbine_____?
A. is same
B. is different
C. increases from one side to the other side
D. decreases from one side to the other side
The value of reheat factor normally varies from___________?
A. 0.5 to 0.6
B. 0.9 to 0.95
C. 1.02 to 1.06
D. 1.2 to 1.6
In a surface condenser if air is removed, there is___________?
A. fall in absolute pressure maintained in condenser
B. rise in absolute pressure maintained in condenser
C. no change in absolute pressure in the condenser
D. rise in temperature of condensed steam
In hydro power plant, the graph between discharge and time is known as___________?
A. monograph.
B. load graph.
C. discharge graph.
D. hydro graph
For the safety of a steam boiler the number of safety valves fitted are____________?
A. four
B. three
C. two
D. one
Blowing down of boiler water is the process_____________?
A. to reduce the boiler pressure
B. to increase the steam temperature
C. to control the solid concentration in the boiler water by removing some of the concentrated saline water
D. none of the above
A steam power stations basically work on the______________?
A. thermodynamic cycle
B. Rankin cycle
C. Vapor pressure cycle
D. Carton cycle
Which of the following device is used to measure vacuum?
A. Barometer
B. Hygrometer
C. U-tube manometer
D. Venturi metre
The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency
Recent Comments