Search
.Management Sciences
Category: Power Generation
The overall efficiency of a steam power station is ________ its thermal efficiency.
A. less than
B. equal to
C. greater than
D. none of the above
Which of the following power plant usually offer highest maintenance cost___________?
A. Nuclear power plants
B. Hydro-electric power plants
C. Thermal power plants
D. Diesel engine power plant
The cooling section in the surface condenser__________?
A. increases the quantity of vapour extracted along with air
B. reduces the quantity of vapour extracted along with air
C. does not affect vapour quantity extracted but reduces pump capacity of air extraction pump
D. none of the above
Which of the following generating station has minimum running cost?
A. Nuclear
B. Hydro
C. Thermal
D. Diesel
In case of impulse steam turbine_____________?
A. there is enthalpy drop in fixed and moving blades
B. there is enthalpy drop only in moving blades
C. there is enthalpy drop in nozzles
D. none of the above
Solar thermal power generation can be achieved by_______________?
A. using focusing collector or heliostates
B. using flat plate collectors
C. using a solar pond
D. any of the above system
In De Laval steam turbine___________?
A. the pressure in the turbine rotor is approximately same as in con¬denser
B. the pressure in the turbine rotor is higher than pressure in the con¬denser
C. the pressure in the turbine rotor gradually decreases from inlet to exit from condenser
D. none from the above
Steam turbines commonly used in steam power station are__________?
A. condensing type
B. non-condensing type
C. none of the above
In regenerative cycle feed water is heated by_____________?
A. exhaust gases
B. heaters
C. draining steam from the turbine
D. all above
The critical pressure ratio of a convergent nozzle is defined as_____________?
A. the ratio of outlet pressure to inlet pressure of nozzle
B. the ratio of inlet pressure to outlet pressure of nozzle
C. the ratio of outlet pressure to inlet pressure only when mass flow rate per unit area is minimum
D. the ratio of outlet pressure to inlet pressure only when mass flow rate = c
Recent Comments