Search
.Management Sciences
Category: Power Generation
The pressure at the furnace is minimum in case of___________?
A. forced draught system
B. induced draught system
C. balanced draught system
D. natural draught system
The commercial sources of energy are____________?
A. solar, wind and biomass
B. fossil fuels, hydropower and nuclear energy
C. wood, animal wastes and agriculture wastes
D. none of the above
Artificial draught is produced by____________?
A. air fans
B. steam jet
C. fan or steam jet
D. all of the above
In a regenerative feed heating cycle, the optimum value of the fraction of steam extracted for feed heating________________?
A. decreases with increase in Rankine cycle efficiency
B. increases with increase in Rankine cycle efficiency
C. is unaffected by increase in Rankine cycle efficiency
D. none of the above
The draught produced by chimney of given height at given outside temperature___________?
A. decreases if the chimney gas temperature increases
B. increases if the chimney gas temperature increases
C. remains same irrespective of chimney gas temperature
D. may increase or decrease
Binary’vapour cycles are used to_____________?
A. increase the performance of the condenser
B. increase the efficiency of the plant
C. increase efficiency of the turbine
In a regenerative surface condenser_____________?
A. there is one pump to remove air and condensate
B. there are two pumps to remove air and condensate
C. there are three pumps to remove air, vapour and condensate
D. there is no pump, the condensate gets removed by gravity
Deaerative heating is done to_____________?
Deaerative heating is done to
A. heat the water
B. heat the air in the water
C. remove dissolved gases in the water
Recent Comments