Search
.Management Sciences
Category: Strength of Materials
Which of the following is not the unit of energy________________?
A. kg m
B. kcal
C. wattr
D. watt hours
E. kg m x (m/sec)2
The effort required to lift a load W on a screw jack with helix angle a and angle of friction <j) is equal to_________________?
A. Wtan(a + )
B. Wtan(a-)
C. Wcos(a + )
D. Wsin(a + )
E. W (sin a + cos )
The magnitude of two forces, which when acting at right angle produce resultant force of VlOkg and when acting at 60° produce resultant of Vl3 kg. These forces are____________________?
A. 2 and V6
B. 3 and 1 kg
C. V5andV5
D. 2 and 5
E. none of the above
A sample of metal weighs 219 gms in air, 180 gms in water, 120 gms in an unknown fluid. Then which is correct statement about density of metal________________?
A. density of metal can’t be determined
B. metal is twice as dense as water
C. metal will float in water
D. metal is twice as dense as unknown fluid
E. none of the above
Center of gravity of a thin hollow cone lies on the axis at a height of________________?
A. one-fourth of the total height above base
B. one-third of the total height above base
C. one-half of the total height above base
D. three-eighth of the total height above the base
E. none of the above
Center of gravity of a solid cone lies on the axis at the height_______________?
A. one-fourth of the total height above base
B. one-third of the total height above base
C. one-half of the total height above base
D. three-eighth of the total height above the base
E. none of the above
The ratio of limiting friction and normal reaction is known as_______________?
A. coefficient of friction
B. angle of friction
C. angle of repose
D. sliding friction
E. friction resistance
The maximum frictional force which comes into play when a body just begins to slide over another surface is called_____________________?
A. limiting friction
B. sliding friction
C. rolling friction
D. kinematic friction
E. dynamic friction
On a ladder resting on smooth ground and leaning against vertical wall, the force of friction will be__________________?
A. towards the wall at its upper end
B. away from the wall at its upper end
C. upwards at its upper end
D. downwards at its upper end
E. none of the above
In the lever of third order, load W, effort P and fulcrum F are oriented as follows_________________?
A. W between P and F
B. F between W and P
C. P between W and F
D. W, P and F all on one side
E. none of the above
Recent Comments