Search
.Management Sciences
Category: Process Equipment and Plant Design
Speed of the drum of the rotary vacuum filter normally ranges from _____________ rpm?
A. 0.1 to 2
B. 5 to 7
C. 3 to 8
D. 8 to 15
Ratio of tube length to shell diameter for a shell and tube heat exchanger is________________?
A. 8 : 1 to 12 : 1 for both liquid-liquid and gas-gas heat exchangers
B. 4 : 1 to 8 : 1 for liquid-liquid exchanger
C. < 4 : 1 for gas-gas exchangers
D. Both B. & C.
The maximum liquid gradient over a tray must not exceed__________________?
A. 0.5″ -1.25″
B. 2″-3.5″
C. 5″
D. Half the tray spacing
In case of a continuous distillation column, increase in reflux ratio may result in the______________?
A. Lower fixed charges for the column
B. Greater cost for the reboiler heat supply
C. Greater cost for the condenser coolant
D. All A., B. and C.
Normally, the plate thickness of the bottoms and roofs of vertically cylindrical storage vessels as compared to that of the cylindrical shell is____________?
A. More
B. Less
C. Same
D. More or less depending upon the pressure & temperature inside the vessel and the nature of
the fluid contained therein
The retention time of material in a rotary dryer depends upon its ______________________?
A. rpm
B. Slope & length
C. Flights arrangement
D. All A., B. and C.
Overall distillation column efficiency for most of the refinery columns can be given by (for μ = 0.07 – 1.4 cp and relative volatility < 4) (where ε = overall column efficiency, % μ = molal average viscosity of feed at average column temperature and pressure, cp Δp = pressure drop per tray, psi) ?
A. η = 17 – 61.1 log μ
B. η = 24.6 (Δp/μ)
C. η = 1.66 – 0.25 log μ
D. η = 0.25 log μ – 1.67
For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is_________________?
A. d1/(d1 + d2)
B. d2/(d1 + d2)
C. (d1 + d2)/d1
D. (d1 + d2)/d2
Recent Comments