Search
.Management Sciences
Category: Mass Transfer
The most common packing used in industrial operations is _______________ rings?
A. Raschig
B. Lessing
C. Cross-partition
D. Single spiral
Chemisorption (chemical adsorption) is_______________________?
A. Same as “Van der Waals” adsorption
B. Characterised by adsorption of heat
C. An irreversible phenomenon
D. A reversible phenomenon
For gas absorption, low viscosity solvents are preferred, because of their ____________________?
A. Better flow characteristics
B. Low pumping pressure drop
C. Rapid absorption rates
D. All A., B. and C.
In a distillation operation, what is the effect of the temperature of the reflux stream (given below) on the condenser and reboiler loads? Reflux conditions: (i) Reflux stream is completely liquid and is at its bubble point. (ii) Reflux stream is below its bubble point ?
A. Condenser and reboiler loads are the same in both the cases
B. Reboiler load is the same in both the cases but condenser load is higher in case (ii)
C. Condenser load is the same in both the cases but reboiler load is higher in case (ii)
D. Both condenser and reboiler loads are higher in case (ii) as compared to case (i)
In case of liquid-liquid binary diffusion, diffusivity of one constituent into another is not dependent on the__________________?
A. Temperature and pressure
B. Concentration
C. Nature of the constituents
D. None of these
The efficiency of a plate column will be maximum, when the flow is ideal __________________ the plate?
A. Across
B. Above
C. Both A. & B.
D. Neither A. nor B.
For continuous drying of granular or crystalline material, the dryer used is the _______________ dryer?
A. Tunnel
B. Tray
C. Rotary
D. None of these
Equilibrium moisture of a solid is equal to the total moisture minus free moisture. Which of the following substances will have maxi-mum equilibrium moisture ?
A. Anthracite coal
B. Rag paper
C. Bamboo
D. Inorganic solids
Recent Comments