Search
.Management Sciences
A good voltage regulation of a transformer means
A. output voltage fluctuation from no load to full load is least
B. output voltage fluctuation with power factor is least
C. difference between primary and secondary voltage is least
D. difference between primary and secondary voltage is maximum
Related Mcqs:
- A transformer cannot raise or lower the voltage of a D.C. supply because_______________?
- A. there is no need to change the D.C. voltage B. a D.C. circuit has more losses C. Faraday’s laws of electromagnetic induction are not valid since the rate of change of flux is zero D. none of the above...
- What will happen if the transformers working in parallel are not connected with regard to polarity ?
- A. The power factor of the two trans-formers will be different from the power factor of common load B. Incorrect polarity will result in dead short circuit C. The transformers will not share load in proportion to their kVA ratings D. none of the above...
- The changes in volume of transformer cooling oil due to variation of atmospheric temperature during day and night is taken care of by which part of transformer?
- A. Conservator B. Breather C. Bushings D. Buchholz relay...
- An open-circuit test on a transformer is conducted primarily to measure______________?
- A. insulation resistance B. copper loss C. core loss D. total loss E. efficiency F. none of the above...
- Reduction in core losses and increase in permeability are obtained with transformer employing__________?
- A. core built-up of laminations of cold rolled grain oriented steel B. core built-up of laminations of hot rolled sheet C. either of the above D. none of the above...
Recent Comments