Load curve is useful in deciding the__________?

Power Generation 20/09/2020

(a) A. operating schedule of generating units
B. sizes of generating units
C. total installed capacity of the plant
D. all of the above

Related Mcqs:

    Rankine cycle efficiency of a good steam power plant may be in the range of____________?
    A. 15 to 20 per cent B. 35 to 45 per cent C. 70 to 80 per cent D. 90 to 95 per ceut...
    The artificial draught normally is designed to produce____________?
    A. less smoke B. more draught C. less chimney gas temperature D. all of the above...
    In a surface condenser if air is removed, there is___________?
    A. fall in absolute pressure maintained in condenser B. rise in absolute pressure maintained in condenser C. no change in absolute pressure in the condenser D. rise in temperature of condensed steam...
    Blowing down of boiler water is the process_____________?
    A. to reduce the boiler pressure B. to increase the steam temperature C. to control the solid concentration in the boiler water by removing some of the concentrated saline water D. none of the above...
    If the load factor of a power station is high then its cost of generation will be_______?
    A. High. B. Low. C. Remain same. D. Depend upon plant type....

Leave a Reply

Your email address will not be published. Required fields are marked *