Transformer utilization factor is a measure of the merit of a rectifier circuit. It is the ratio of_______________?

Power Electronics 25/08/2021

A. AC input power to the transformer volt – amp rating required by secondary
B. AC input power to the transformer volt – amp rating required by primary
C. DC output power to the transformer volt – amp rating required by secondary
D. DC output power to the transformer volt – amp rating required by primary

Related Mcqs:

    A single phase one pulse controlled circuit has a resistance R and counter emf E load 400 sin(314 t) as the source voltage. For a load counter emf of 200 V, the range of firing angle control is _____?
    A. 30° to 150°. B. 30° to 180°. C. 60° to 120°. D. 60° to 180°....
    How can we protect SCR from thermal conditions _____________?
    A. Use of snubber circuit. B. Using heat sink. C. Using CB and fuse. D. Using equalizing circuit...
    A string of n parallel SCRs is operated at 72 KA, the rating of each SCR is 1 KA. If derating factor of the string is 0.1. value of n will be___________?
    A. 60 B. 70 C. 80 D. 90...
    The average value of the output voltage in a step – down dc chopper is given by__________?
    A. V 0 = V s B. V 0 = D V s C. V 0 = V s / D D. V 0 = V s / ( 1 – D )...
    The ac output voltage waveform of VSI and AC output current waveform of CSI respectively is composed of___________?
    A. High dv / dt, low di / dt B. Low dv / dt, low di / dt C. Low dv / dt, high di / dt D. High dv / dt, high di / dt...

Leave a Reply

Your email address will not be published. Required fields are marked *